Suzuki SFV650 - Page 267

Engine Mechanical: 1D-78
Generator Cover
• Install the dowel pins (1), gasket (2) and clutch push
rod (3).
CAUTION
!
Use the new gasket to prevent oil leakage.
• Apply a small quantity of grease to the push rod (3).
: Grease 99000–25010 (SUZUKI SUPER
GREASE A or equivalent)
• Install the generator cover (4), clutch cable stopper (5)
and clamp (6).
• Fit the gasket washer to the generator cover mounting
bolts “A” correctly as shown.
CAUTION
!
Use the new gasket washer to prevent oil
leakage.
• Tighten the generator cover mounting bolts to the
specified torque.
Tightening torque
Generator cover mounting bolt: 10 N·m (1.0 kgf-
m, 7.0 lbf-ft)
Starter Motor
• Apply grease to the O-ring.
: Grease 99000–25010 (SUZUKI SUPER
GREASE A or equivalent)
CAUTION
!
Replace the O-ring with a new one.
• Fit the clamp (1) to the starter motor mounting bolt “A”
as shown.
• Tighten the starter motor mounting bolts (2) to the
specified torque.
Tightening torque
Starter motor mounting bolt (a): 10 N·m (1.0 kgf-
m, 7.0 lbf-ft)
Engine Top Side
• Assembly the engine top side. Refer to “Engine Top
Side Assembly (Page 1D-31)”.
1
1
2
3
I944H1140110-01
4
5
6
“A”
I944H1140111-02
I944H1140112-01
1
(a)
2
I944H1140113-02