Suzuki SFV650 - Page 266

1D-77 Engine Mechanical:
• Tighten the oil pipe stopper screw (2) to the specified
torque.
NOTE
Align the projection “A” of the oil pipe with
the groove “B” of its stopper.
Tightening torque
Oil pipe stopper screw (a): 8 N·m (0.8 kgf-m, 6.0
lbf-ft)
Oil Pump
• Tighten the oil pump mounting bolts (1).
• Install the washer (2) and pin (3).
NOTE
Be careful not to drop the washer (2) and pin
(3) into the crankcase.
• Install the oil pimp driven gear (4) and snap ring (5).
CAUTION
!
Replace the snap ring with a new one.
Special tool
: 09900–06107 (Snap ring pliers)
Clutch
Install the clutch component parts (1). Refer to “Clutch
Installation in Section 5C (Page 5C-9)”.
Starter Idle Gear
• Apply engine oil to both ends of the shaft (1).
• Install the starter idle gear (2) and shaft (1).
(a)
2
“A”
“B”
I944H1140105-01
2
3
1
1
I944H1140106-02
4
5
I944H1140107-02
1
I944H1140108-01
2
1
I944H1140109-02