Engine Mechanical: 1D-76
• Apply thread lock to the gearshift cam stopper plate
bolt (6) and tighten it to the specified torque.
: Thread lock cement 99000–32110
(THREAD LOCK CEMENT SUPER 1322 or
equivalent)
Tightening torque
Gearshift cam stopper plate bolt (b): 13 N·m (1.3
kgf-m, 9.5 lbf-ft)
• Apply thread lock to the gearshift arm stopper (7) and
tighten it to the specified torque.
: Thread lock cement 99000–32030
(THREAD LOCK CEMENT SUPER 1303 or
equivalent)
Tightening torque
Gearshift arm stopper (c): 19 N·m (1.9 kgf-m, 13.5
lbf-ft)
• Install the gearshift shaft assembly (8) and washers
(9) as shown in the figure.
NOTE
Pinch the gearshift arm stopper (7) with
return spring ends “D”.
• Install the washer (10) and snap ring (11).
CAUTION
!
Replace the snap ring with a new one.
Special tool
: 09900–06107 (Snap ring remover (Open
type))
Oil Pipe
• Install the oil pipe (1).
(b)
6
I944H1140098-02
(c)
7
I944H1140100-01
8
9
I944H1140101-01
7
“D”
“D”
I944H1140102-01
10
11
I944H1140103-01
1
I944H1140104-01
To Next Page
Loading...
