1D-75 Engine Mechanical:
• Tighten the union bolt (1) to the specified torque.
Tightening torque
Oil cooler union bolt (a): 70 N·m (7.0 kgf-m, 50.5
lbf-ft)
Oil Filter
• Install the oil filter with the special tool. Refer to
“Engine Oil and Filter Replacement in Section 0B
(Page 0B-10)”.
Special tool
(A): 09915–40620 (Oil filter wrench)
Gearshift System
• Install the gearshift cam stopper (1), bolt (2), washer
(3) and return spring (4).
• Tighten the gearshift cam stopper bolt (2) to the
specified torque.
NOTE
Hook the return spring end “A” to the
stopper (1).
Tightening torque
Gearshift cam stopper bolt (a): 10 N·m (1.0 kgf-
m, 7.0 lbf-ft)
• Check the gearshift cam stopper moves smoothly.
• Locate the gearshift cam in the neutral position.
• Install the gearshift cam stopper plate (5).
NOTE
Align the gearshift cam pins “B” with the
gearshift cam stopper plate holes “C”.
(a)
1
I944H1140093-01
(A)
I944H1140094-01
1
2
3
4
I944H1140095-01
“A”
1
(a)
2
I944H1140096-01
“C”
“B”
5
I944H1140097-01
To Next Page
Loading...
