Engine Mechanical: 1D-74
• Tighten the cam chain tensioner bolt (5) to the
specified torque.
Tightening torque
Cam chain tensioner bolt (a): 10 N·m (1.0 kgf-m,
7.0 lbf-ft)
Primary Drive Gear
• Install the primary drive gear (1) and water pump drive
gear (2).
• Hold the generator rotor with the special tool.
Special tool
(A): 09930–44530 (Rotor holder)
• Tighten the primary drive gear bolt (3) to the specified
torque.
Tightening torque
Primary drive gear bolt (a): 70 N·m (7.0 kgf-m,
50.5 lbf-ft)
Oil Pressure Switch
• Apply bond to the thread part of the oil pressure
switch (1) and tighten the oil pressure switch (1) to the
specified torque.
NOTE
Be careful not to apply bond to the hole of
thread end.
: Sealant 99000–31140 (SUZUKI BOND
No.1207B or equivalent)
Tightening torque
Oil pressure switch (a): 14 N·m (1.4 kgf-m, 10.0
lbf-ft)
Oil Cooler
• Apply grease to the O-ring.
CAUTION
!
Use a new O-ring to prevent oil leakage.
NOTE
When install the oil cooler, fit the convex part
“A” of the left crankcase onto the concave
part “B” of the oil cooler.
: Grease 99000–25010 (SUZUKI SUPER
GREASE A or equivalent)
(a)
5
4
(a)
5
3
I944H1140088-01
1
2
I944H1140089-01
(A)
(a)
3
I944H1140090-03
(a)
1
I944H1140091-01
“A”
“B”
I944H1140092-01
To Next Page
Loading...
