Suzuki SFV650 - Page 289

Engine Lubrication System: 1E-10
2) Remove the oil gallery jets (1) (for cylinder).
3) Remove the plates (2).
4) Remove the piston cooling oil jets (3).
Installation
Installation is in the reverse order of removal. Pay
attention to the following points:
• Fit new O-rings to piston cooling oil jets (1) and oil
gallery jets (2) (for cylinder) as shown.
CAUTION
!
Use new O-rings to prevent oil pressure
leakage.
• Apply grease to O-rings.
: Grease 99000–25010 (SUZUKI SUPER
GREASE A or equivalent)
• Apply a small quantity of thread lock to the bolts (3)
and tighten them to the specified torque.
: Thread lock cement 99000–32110
(THREAD LOCK CEMENT SUPER 1322 or
equivalent)
Tightening torque
Piston cooling oil jet bolt (a): 10 N·m (1.0 kgf-m,
7.0 lbf-ft)
Oil Jet (For Transmission)
Removal
1) Drain engine oil. Refer to “Engine Oil and Filter
Replacement in Section 0B (Page 0B-10)”.
2) Remove the generator cover. Refer to “Generator
Removal and Installation in Section 1J (Page 1J-4)”.
3) Remove the engine sprocket. Refer to “Engine
Sprocket Removal and Installation in Section 3A
(Page 3A-2)”.
4) Remove the oil seal retainer mounting bolts (1).
5) Remove the clutch push rod oil seal (2).
1
1
I944H1150048-01
2
3
I944H1150049-01
1
2
I944H1150022-02
(a)
3
I944H1150050-01
1
1
I944H1150023-02
2
I944H1150024-01