Suzuki SFV650 - Page 290

1E-11 Engine Lubrication System:
6) Remove the oil gallery plug (M8) (3).
7) Remove the oil gallery plug (M6) (4) if necessary.
8) Remove the oil gallery jet (for transmission) (5) with
a suitable bar (6).
Installation
Installation is in the reverse order of removal. Pay
attention to the following points:
• Apply grease to the O-ring.
CAUTION
!
Use a new O-ring to prevent oil leakage.
: Grease 99000–25010 (SUZUKI SUPER
GREASE A or equivalent)
• Install the oil gallery jet (for transmission) (1) with a
suitable bar.
• Tighten the oil gallery plug (M8) (2) and (M6) (3) to the
specified torque.
CAUTION
!
Use new gaskets to prevent oil leakage.
Tightening torque
Oil gallery plug (M8) (a): 18 N·m (1.8 kgf-m, 13.0
lbf-ft)
Oil gallery plug (M6) (b): 10 N·m (1.0 kgf-m, 7.0
lbf-ft)
• Install the clutch push rod oil seal (4) with the special
tool.
CAUTION
!
Use a new oil seal to prevent oil leakage.
Special tool
(A): 09913–70210 (Bearing installer set)
• Apply grease to lip of clutch push rod oil seal.
: Grease 99000–25010 (SUZUKI SUPER
GREASE A or equivalent)
• Reinstall the engine sprocket. Refer to “Engine
Sprocket Removal and Installation in Section 3A
(Page 3A-2)”.
• Reinstall the generator cover. Refer to “Generator
Removal and Installation in Section 1J (Page 1J-4)”.
3
4
I944H1150025-01
5
6
I944H1150026-02
1
1
I944H1150027-02
(b)
3
(a)
2
I944H1150028-01
4
(A)
I944H1150029-02