Suzuki SFV650 - Page 489

Manual Transmission: 5B-15
4) Remove the snap ring (2) and washer (3) from the
gearshift shaft.
Special tool
: 09900–06107 (Snap ring pliers)
5) Remove the gearshift shaft assembly (4) and washer
(5).
6) Remove the following parts from the gearshift shaft
(6).
• Snap ring (7)
• Gearshift return spring (8)
• Gearshift cam drive plate (9)
• Plate return spring (10)
• Washer (11)
Special tool
: 09900–06107 (Snap ring pliers)
7) Remove the gearshift cam plate bolt (12) and
gearshift cam plate (13).
8) Remove the gearshift cam stopper (14).
NOTE
Do not drop the each parts into the
crankcase.
9) Remove the gearshift arm stopper (15).
Installation
Install the gearshift shaft and gearshift cam plate in the
reverse order of removal. Pay attention to the following
points:
CAUTION
!
The removed snap rings must be replaced
with new ones.
2
3
I944H1520049-02
4
5
I944H1520050-02
6
7
7
8
9
11
11
10
I944H1520051-01
12
13
14
I944H1520052-01
15
I944H1520053-01