5B-16 Manual Transmission:
• Apply a small quantity of thread lock to the gearshift
arm stopper (1) and tighten it to the specified torque.
: Thread lock cement 99000–32030
(THREAD LOCK CEMENT SUPER 1303 or
equivalent)
Tightening torque
Gearshift arm stopper (a): 19 N·m (1.9 kgf-m, 13.5
lbf-ft)
• Install the gearshift cam stopper (2), bolt (3), washer
(4) and return spring (5).
• Tighten the gearshift cam stopper bolt (3) to the
specified torque.
NOTE
Hook the return spring end “A” to the
stopper (2).
Tightening torque
Gearshift cam stopper bolt (b): 10 N·m (1.0 kgf-
m, 7.0 lbf-ft)
• Check the gearshift cam stopper moves smoothly.
• Locate the gearshift cam in the neutral position.
• Install the gearshift cam stopper plate (6).
NOTE
Align the gearshift cam pins “B” with the
gearshift cam stopper plate holes “C”.
• Apply a small quantity of thread lock to the gearshift
cam stopper plate bolt (7) and tighten it to the
specified torque.
: Thread lock cement 99000–32110
(THREAD LOCK CEMENT SUPER 1322 or
equivalent)
Tightening torque
Gearshift cam stopper plate bolt (c): 13 N·m (1.3
kgf-m, 9.5 lbf-ft)
• When installing the gearshift shaft return spring,
position the stopper “D” of gearshift arm between the
shaft return spring ends “E”.
(a)
1
I944H1520054-02
2
3
5
4
I944H1520055-01
(b)
3
“A”
2
I944H1520056-02
“C”
“B”
6
I944H1520057-01
(c)
7
I944H1520058-01
“D”
“E”
I944H1520059-01
To Next Page
Loading...
