ME310G1/ME910G1/ML865G1 AT Commands Reference Guide
80617ST10991A Rev.4 Page 108 of 545 2020-04-15
3.1.4.14. ATX - Extended Result Codes
Set command selects the subset of result code messages the modem uses to reply to the DTE upon AT
commands execution.
ITU-T Recommendation V.25 ter
when entering in dial mode a CONNECT result code is relayed; see
Additional info.
when entering in dial mode a CONNECT <text> result code is relayed, see
Additional info.
<n>=0
OK, CONNECT, RING, NO CARRIER, ERROR, NO ANSWER result codes are enabled.
Dial tone and busy detection (NO DIALTONE and BUSY result codes) are disabled.
<n>=1÷4
all the remaining result codes are enabled.
When the <n> parameter is omitted, the command acts like ATX0.