Telit Wireless Solutions ML865G1 At Commands Reference Guide

ME310G1/ME910G1/ML865G1 AT Commands Reference Guide
80617ST10991A Rev.4 Page 362 of 545 2020-04-15
3.13.4. AT#SGACTCFGEXT - Extended PDP Context Configuration
This command manages the extended configuration of context activation.
SIM Presence
Setting saved
Can be aborted
MAX timeout
SELINT
Required
Auto
No
-
2
AT#SGACTCFGEXT=<cid>,<abortAttemptEnable>[,<unused>[,<unused>[,<unused>]]]
Set command is used to enable new features related to context activation.
Parameters:
Name
Type
Default
Description
<cid>
integer
-
PDP context identifier. To know the range see
+CGDCONT command.
<abortAttemptEnable>
integer
0
enables/disables abort during context activation
attempt.
Values:
0
:
old behavior: no abort possible while attempting context
activation
1
:
abort during context activation attempt is possible by
sending a byte on the serial port
<unused>
mixed
N/A
unused parameter
Value:
0
:
dummy value
<unused>
mixed
N/A
unused parameter
Value:
0
:
dummy value
<unused>
mixed
N/A
unused parameter
Value:
0
:
dummy value
<abortAttemptEnable>=1 takes effect on successive PDP context activation attempt
through #SGACT command. While waiting for AT#SGACT=<cid>,1 response, it is
possible to abort attempt by sending a byte and get back AT interface control (NO
CARRIER indication).
If we receive delayed CTXT ACTIVATION ACCEPT after abort, network will be
automatically informed of our aborted attempt through relative protocol messages (SM
STATUS) and will also close on its side.
Otherwise, if no ACCEPT is received after abort, network will be informed later of our
PDP state through other protocol messages (routing area update for instance).
The command is not effective while the context is already open.

Telit Wireless Solutions ML865G1 Specifications

General

Brand	Telit Wireless Solutions
Model	ML865G1
Category	Wireless modules
Language	English