Telit Wireless Solutions ML865G1 At Commands Reference Guide

ME310G1/ME910G1/ML865G1 AT Commands Reference Guide
80617ST10991A Rev.4 Page 18 of 545 2020-04-15
If command V1 is enabled (verbose responses codes) and all commands in a command line has been
performed successfully, result code <CR><LF>OK<CR><LF> is sent from the TA to the TE, if sub parameter
values of a command are not accepted by the TA or command itself is invalid, or command cannot be
performed for some reason, result code <CR><LF>ERROR<CR><LF> is sent and no subsequent commands
in the command line are processed.
If command V0 is enabled (numeric responses codes), and all commands in a command line has been
performed successfully, result code 0<CR> is sent from the TA to the TE, if sub-parameter values of a
command are not accepted by the TA or command itself is invalid, or command cannot be performed for some
reason, result code 4<CR> and no subsequent commands in the command line are processed.
In case of errors depending on ME operation, ERROR (or 4) response may be replaced by +CME ERROR:
<err> or +CMS ERROR: <err>.
The command line buffer accepts a maximum of 400 characters. If this number is
exceeded none of the commands will be executed and TA returns ERROR.
2.2.2.1. ME Error Result Code - +CME ERROR: <err>
This is NOT a command, it is the error response to +Cxxx 3GPP TS 27.007 commands.
Syntax: +CME ERROR: <err>
Parameter: <err> - error code can be either numeric or verbose (see +CMEE). The possible values of <err>
are reported in the table:
Numeric Format
3
Verbose Format
4
0
phone failure
1
no connection to phone
2
phone adaptor link reserved
3
operation not allowed
4
operation not supported
5
PH-SIM PIN required
6
PH-FSIM PIN required
7
PH-FSIM PUK required
10
SIM not inserted
11
SIM PIN required
12
SIM PUK required
13
SIM failure
14
SIM busy
15
SIM wrong
16
incorrect password
17
SIM PIN2 required
18
SIM PUK2 required
20
memory full
21
invalid index
22
not found
23
memory failure
24
text string too long
25
invalid characters in text string
26
dial string too long
27
invalid characters in dial string
30
no network service
31
network timeout
32
network not allowed - emergency calls only
34
numeric parameter instead of text parameter
35
text parameter instead of numeric parameter
36
numeric parameter out of bounds
37
text string too short
3
Not all modules support the error codes shown in the table.
4
There could be small variations in the message depending on the module in use.

Telit Wireless Solutions ML865G1 Specifications

General

Brand	Telit Wireless Solutions
Model	ML865G1
Category	Wireless modules
Language	English