ME310G1/ME910G1/ML865G1 AT Commands Reference Guide
80617ST10991A Rev.4 Page 15 of 545 2020-04-15
Icons and Text Conventions
SET section – This section provides all information related to SET functionality of
involved AT command. If it has got strictly and relevant SET information, these are
located at section end.
READ section – This section provides all information related to READ functionality of
involved AT command. If it has got strictly and relevant READ information, these are
located at section end.
TEST section – This section provides all information related to TEST functionality of
involved AT command. If it has got strictly and relevant TEST information, these are
located at section end.
Additional info – This section provides any kind of additional and useful information
related to the AT command section as well as command exceptions or special
behavior cases.
REFERENCE section – This section provides useful references (standards or
normative) related to involved AT command.
EXAMPLE section – This section provides useful examples related to involved AT
command.
NOTE section – This section provides all information related to involved AT
commands. Each note can provide a different level of information: danger,
caution/warning and tip/information.
Danger – This information MUST be followed or catastrophic equipment failure or
bodily injury may occur.
Caution or Warning – Alerts the user to important points about integrating the module,
if these points are not followed, the module and end user equipment may fail or
malfunction.
Tip or Information – Provides advice and suggestions that may be useful when
integrating the module.
All dates are in ISO 8601 format, i.e. YYYY-MM-DD.
To Next Page
Loading...
Need help?
General
