Telit Wireless Solutions ML865G1 At Commands Reference Guide

ME310G1/ME910G1/ML865G1 AT Commands Reference Guide
80617ST10991A Rev.4 Page 119 of 545 2020-04-15
3.2.5. AT+CLCK - Facility Lock/Unlock
This command is used to lock or unlock a ME on a network facility.
3GPP TS 27.007
SIM Presence
Setting saved
Can be aborted
MAX timeout
SELINT
Not required
No
No
-
2
AT+CLCK=<fac>,<mode>[,<password>[,<class>]]
Set command is used to lock, unlock or interrogate a modem or a network lock facility. Password is
normally needed to do such actions
Parameters:
Name
Type
Default
Description
<fac>
string
N/A
facility to lock, unlock or interrogate
Values:
"SC"
:
SIM (PIN request) (device asks SIM password at power-up and
when this lock command issued)
"FD"
:
SIM fixed dialing memory feature (if PIN2 authentication has not
been done during the current session, PIN2 is required as
<passwd>)
<mode>
integer
N/A
defines the operation to be done on the facility
Values:
0
:
unlock facility
1
:
lock facility
2
:
query status
<password>
string
-
shall be the same as password specified for the facility from
the DTE user interface or with command Change Password
+CPWD
<class>
integer
N/A
is a sum of integers, each representing an information class
of which the command refers to; default is 7 (voice + data +
fax).
Values:
1
:
voice (telephony)
2
:
data (refers to all bearer services)
4
:
fax (facsimile services) (not supported by LTE)
8
:
short message service
16
:
data circuit sync
32
:
data circuit async
64
:
dedicated packet access
128
:
dedicated PAD access

Telit Wireless Solutions ML865G1 Specifications

General

Brand	Telit Wireless Solutions
Model	ML865G1
Category	Wireless modules
Language	English