Telit Wireless Solutions ML865G1 At Commands Reference Guide

ME310G1/ME910G1/ML865G1 AT Commands Reference Guide
80617ST10991A Rev.4 Page 118 of 545 2020-04-15
<format> parameter setting is never stored in NVM.
If AT+COPS=0 is issued after the switch-on, it causes a new attempt to select a network
operator and registers the module on the selected operator.
AT+COPS?
Read command returns current value of <mode>, <format>, <oper> and <AcT> in format
<format>. If no operator is selected, <format>, <oper> and <AcT> are omitted.
+COPS: <mode>[, <format>, <oper>,< act>]
If the module is deregistered, <format>, <oper>, and <act> parameters are omitted.
AT+COPS=?
Test command returns a list of quadruplets, each representing an operator present in the network.
The quadruplets list is ended with the range values of the <mode> and <formats> parameters.
The quadruplets in the list are closed between round brackets, separated by commas, the <oper>
parameter is returned in both formats.
+COPS: [quadruplets list (<stat>,<oper (in <format>=0)>,,<oper (in <format>=2)>,< act>),
(<stat>,<oper (in <format>=0)>,,<oper (in <format>=2)>,< act>), ...]
[,,(range of <mode>),(range of <format>)]
<stat> parameter is described in the Additional info section.
Additional info:
Meaning of the <stat> parameter.
Name
Type
Default
Description
<stat>
integer
N/A
operator availability
Values:
0
:
unknown
1
:
available
2
:
current
3
:
forbidden
Since with this command a network scan is done, this command may require some
seconds before the output is given.

Telit Wireless Solutions ML865G1 Specifications

General

Brand	Telit Wireless Solutions
Model	ML865G1
Category	Wireless modules
Language	English