Telit Wireless Solutions ML865G1 At Commands Reference Guide

ME310G1/ME910G1/ML865G1 AT Commands Reference Guide
80617ST10991A Rev.4 Page 333 of 545 2020-04-15
Packet Domain
3.12.1. AT+CGDCONT - Define PDP Context
Define PDP Context.
3GPP TS 27.007
SIM Presence
Setting saved
Can be aborted
MAX timeout
SELINT
Required
Auto
No
-
2
AT+CGDCONT=[<cid>[,<PDP_type>[,<APN>[,<PDP_addr>[,<d_comp>[,<h_comp>[,<IPv4AddrAll
oc>[,<emergencyIndication>]]]]]]]]
Set command specifies PDP context parameter values for a PDP context identified by the (local)
context identification parameter, <cid>.
Parameters:
Name
Type
Default
Description
<cid>
integer
-
(PDP Context Identifier) numeric parameter
which specifies a particular PDP context
definition.
1..max - where the value of max is returned by
the Test command.
<PDP_type>
string
N/A
(Packet Data Protocol type) a string parameter
which specifies the type of packet data
protocol.
Values:
"IP"
:
Internet Protocol
"IPV6"
:
Internet Protocol version 6
"IPV4V6"
:
Virtual introduced to handle dual IP stack UE
capability.
Non-IP
:
Transfer of Non-IP data to external packet data
network
<APN>
string
-
(Access Point Name) a string parameter which
is a logical name that is used to select the
GGSN or the external packet data network. If
the value is empty ("") or omitted, then the
subscription value will be requested.
<PDP_addr>
string
-
A string parameter that identifies the terminal in
the address space applicable to the PDP. The
allocated address may be read using the
+CGPADDR command.
<d_comp>
integer
0
Numeric parameter that controls PDP data
compression.
Values:
0
:
PDP data compression off (default if value is omitted)
1
:
PDP data compression on

Telit Wireless Solutions ML865G1 Specifications

General

Brand	Telit Wireless Solutions
Model	ML865G1
Category	Wireless modules
Language	English