ME310G1/ME910G1/ML865G1 AT Commands Reference Guide
80617ST10991A Rev.4 Page 164 of 545 2020-04-15
3.2.32. AT#CEDRXS - Extended eDRX Setting
This command controls the setting of the UEs eDRX parameters.
3GPP TS 27.007
3GPP TS 24.008
AT#CEDRXS=[<mode>[,<AcTtype>[,<Req_eDRX>[,<ReqPagTimeWindow>]]]]
Set command controls the setting of the UEs eDRX parameters. The command controls whether
the UE wants to apply eDRX or not, as well as the requested eDRX value for each specified type of
access technology.
Parameters:
disable or enable the use of eDRX in the UE.
This parameter is applicable to all specified
types of access technology, i.e. the most recent
setting of <mode> will take effect for all
specified values of <AcT>.
enable the use of eDRX and enable the unsolicited result
code, see Additional info.
disable the use of eDRX and discard all parameters for
eDRX or, if available, reset to the manufacturer specific
default values
type of access technology.
Access technology is not using eDRX. This parameter
value is only used in the unsolicited result code, it cannot
be used in the set command.
half a byte in a 4 bit format. The eDRX value
refers to bit-4 to 1 of octet 3 of the Extended
DRX parameters information element (see
subclause 10.5.5.32 of 3GPP TS 24.008). For
the coding and the value range, see Extended
DRX parameters information element in 3GPP
TS 24.008, Table 10.5.5.32/3GPP TS 24.008.
Default value is "0000"
half a byte in a 4-bit format. The paging time
window refers to bit 8 to 5 of octet 3 of the