EasyManuals Logo

Telit Wireless Solutions ML865G1 At Commands Reference Guide

Telit Wireless Solutions ML865G1
545 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #310 background imageLoading...
Page #310 background image
ME310G1/ME910G1/ML865G1 AT Commands Reference Guide
80617ST10991A Rev.4 Page 310 of 545 2020-04-15
3.8.12. AT#TESTMODE - Test Mode Configuration
Set module in Test Mode for configuring and testing the POWER level (not signaling mode).
SIM Presence
Setting saved
Can be aborted
MAX timeout
SELINT
Not required
Auto
No
-
2
AT#TESTMODE=<cmd>
The Test Mode is entered using the following commands according to the network technology:
AT#TESTMODE="TM" followed by AT#TESTMODE="INIT2G" for 2G networks
AT#TESTMODE="TM" followed by AT#TESTMODE="INIT4G" for 4G networks
Only after this set, AT#TESTMODE can be used with the other allowed commands. To exit from
Test Mode and go back to Operative Mode, enter the command AT#TESTMODE="OM".
Parameter:
Name
Type
Default
Description
<cmd>
string
N/A
identifies one of the commands listed in the Values: section. The
command is a quoted string.
PL4G and PL2G commands must be followed by the value of the
<pwr> power transmission in tenths of dBm:
AT#TESTMODE="PL4G -100"
AT#TESTMODE="PL2G 300"
CH4G command must be followed by the <earfcn> channel and
<bw> bandwidth:
AT#TESTMODE="CHG4 20000 0"
CH2G command must be followed by the <ch> channel and
<band> band:
AT#TESTMODE="CH2G 100 1"
Values:
"TM"
:
forces the module in Test Mode and reboot module
"OM"
:
forces the module in Operative Mode and reboot module
“INIT4G”
:
4G command: initialize Radio for 4G transmission
"CH4G earfcn bw"
:
4G command: set the earfcn UL or DL channel for
transmitting and receiving and set the bandwidth
"PL4G pwr"
:
4G command: change the transmission power. Range is: -
400 ÷ 200 in tenths of dBm
“TX4G"
:
4G command: starts the non-stop module transmission
"RL4G"
:
4G command: reads Rx power level. The value read is in
tenths of dBm
"DEINIT4G"
:
4G command: de-initialize Radio for 4G transmission and
reboot module
“INIT2G”
:
2G command: initialize Radio for 2G transmission
“CH2G ch band”
:
2G command: set the channel and band

Table of Contents

Other manuals for Telit Wireless Solutions ML865G1

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Telit Wireless Solutions ML865G1 and is the answer not in the manual?

Telit Wireless Solutions ML865G1 Specifications

General IconGeneral
BrandTelit Wireless Solutions
ModelML865G1
CategoryWireless modules
LanguageEnglish

Related product manuals