Telit Wireless Solutions ML865G1 At Commands Reference Guide

ME310G1/ME910G1/ML865G1 AT Commands Reference Guide
80617ST10991A Rev.4 Page 359 of 545 2020-04-15
3.13.3. AT#SGACTCFG - PDP Automatic Context Activation-Reactivation
This command configures the automatic activation/reactivation of the specified PDP context
SIM Presence
Setting saved
Can be aborted
MAX timeout
SELINT
Required
Auto
No
-
2
AT#SGACTCFG=<cid>,<retry>[,<delay>[,<urcmode>]]
Set command enables/disables the automatic activation/reactivation of the specified PDP context,
sets the maximum number of attempts and the delay between an attempt and the next one. The
context is automatically activated after every PS attach or after a network PDP context deactivation
if at least one IPEasy socket is configured for that context, see #SCFG command.
Parameters:
Name
Type
Default
Description
<cid>
integer
-
PDP context identifier. To know the range see +CGDCONT
command.
<retry>
integer
0
specifies the maximum number of context activation
attempts in case of activation failure.
0 disables the automatic activation/reactivation of the
context. It is the default value if the set command is not
used, see Example section.
Value:
1÷15
:
number of attempts.
<delay>
integer
180
specifies the delay in seconds between an attempt and the
next one.
180 is the default value if the set command is not used, see
Example section.
Value:
180÷3600
:
delay in seconds
<urcmode>
integer
0
URC presentation mode.
Values:
0
:
disables URC
1
:
enables URC, see Additional info section.
Additional info:
<urcmode>=1
enables the URC after an automatic activation/reactivation of the local IP address obtained
from the network. It has meaning only if <retry>=/=0.
The format of the URC message is:
#SGACT: <ip_address>
Unsolicited field:

Telit Wireless Solutions ML865G1 Specifications

General

Brand	Telit Wireless Solutions
Model	ML865G1
Category	Wireless modules
Language	English