Telit Wireless Solutions ML865G1 At Commands Reference Guide

ME310G1/ME910G1/ML865G1 AT Commands Reference Guide
80617ST10991A Rev.4 Page 191 of 545 2020-04-15
3.3.14. AT+CGLA - Generic UICC Logical Channel Access
This command is used to control the currently selected UICC on the TE.
[1] 3GPP TS 11.11
[2] 3GPP TS 31.101
[3] 3GPP TS 31.102
SIM Presence
Setting saved
Can be aborted
MAX timeout
SELINT
Required
No
No
-
2
AT+CGLA=<sessionId>,<length>,<command>
Set command transmits to the MT the <command> it then shall send as it is to the selected UICC.
In the same manner the UICC <response> shall be sent back by the MT to the TA as it is. This
command allows a direct control of the currently selected UICC by a distant application on the TE.
The TE shall then take care of processing the received UICC information. The response of the
command is in the format:
+CGLA: <length>,<response>
Error case:
+CME ERROR: <err>
The response messages parameters are described in the Additional info section.
Parameters:
Name
Type
Default
Description
<sessionId>
integer
-
this parameter is the identifier of the session to be used
in order to send the APDU commands to the UICC. It is
mandatory to send commands to the UICC when targeting
applications on the smart card using a logical channel other
than the default channel (channel "0").
<sessionId> is returned by the +CCHO command.
<length>
integer
-
characters number of the <command> sent to UICC (two
times the actual length of the command)
<command>
string
-
command passed on by the MT to the UICC in the format as
described in standard [1] or [2] (hexadecimal character
format; refer to +CSCS).
Additional info:
List of the meaning of the response messages parameters.
Name
Type
Default
Description
<length>
integer
-
characters number of the <response> sent to TE
(two times the actual length of the response)

Telit Wireless Solutions ML865G1 Specifications

General

Brand	Telit Wireless Solutions
Model	ML865G1
Category	Wireless modules
Language	English