Telit Wireless Solutions ML865G1 At Commands Reference Guide

ME310G1/ME910G1/ML865G1 AT Commands Reference Guide
80617ST10991A Rev.4 Page 273 of 545 2020-04-15
3.7.2. AT+CALA - Alarm Management
This command is related to the alarm management.
3GPP TS 27.007
SIM Presence
Setting saved
Can be aborted
MAX timeout
SELINT
Not required
Auto
No
-
2
AT+CALA=<time>[,<n>[,<type>[,<text>[,<recurr>[,<silent>]]]]]
Set command stores in the internal Real Time Clock of the module an alarm time with respective
settings.
It is possible to set up a recurrent alarm for one or more days in the week.
• Currently just one alarm can be set.
• Alarms are not supported after disconnecting from power. Coin cell are supported. In case
of a power cut, alarm will be deleted and needs to be re-set.
When the RTC time reaches the alarm time then the alarm starts, the behavior of the module
depends on the setting <type> and if the module was already ON at the moment when the alarm
time had come.
Parameters:
Name
Type
Default
Description
<time>
string
-
current alarm time as quoted string in the format:
"yy/MM/dd,hh:mm:ss±zz"
Refer to +CCLK for the string meaning.
Empty string (+CALA="") deletes the current alarm and
resets all the +CALA parameters to the factory default
configuration.
"hh:mm:ss±zz" string must be used only when issuing
+CALA with parameter <recurr>.
<n>
integer
0
index of the alarm
Value:
0
:
the only value supported
<type>
integer
1
alarm behavior type
Values:
0
:
reserved
1
:
the module wakes up fully operative as if the ON/OFF button has been
pressed. If the module is already ON when the alarm times out, then it
does nothing.
2÷8
:
see Additional info section.
<text>
string
-
alarm code text string used in the URC +CALA. It has
meaning only if <type> is equal to 2, 5 or 6.
<recurr>
string
N/A
sets a recurrent alarm for one or more days in the week in the
following format:

Telit Wireless Solutions ML865G1 Specifications

General

Brand	Telit Wireless Solutions
Model	ML865G1
Category	Wireless modules
Language	English