Telit Wireless Solutions ML865G1 At Commands Reference Guide

ME310G1/ME910G1/ML865G1 AT Commands Reference Guide
80617ST10991A Rev.4 Page 153 of 545 2020-04-15
3.2.26. AT+CEDRXS - eDRX Setting
This command controls the setting of the UEs eDRX parameters.
3GPP TS 27.007
3GPP TS 24.008
SIM Presence
Setting saved
Can be aborted
MAX timeout
SELINT
Not required
Auto
No
-
2
AT+CEDRXS=[<mode>[,<AcTtype>[,<Req_eDRX>]]]
Set command controls the setting of the UEs eDRX parameters. The command controls whether
the UE wants to apply eDRX or not, as well as the requested eDRX value for each specified type of
access technology.
Parameters:
Name
Type
Default
Description
<mode>
integer
0
disable or enable the use of eDRX in the UE. This
parameter is applicable to all specified types of access
technology, i.e. the most recent setting of <mode> will take
effect for all specified values of <AcTtype>.
Values:
0
:
disable the use of eDRX
1
:
enable the use of eDRX
2
:
enable the use of eDRX and enable the unsolicited result code, see
Additional info.
3
:
disable the use of eDRX and discard all parameters for eDRX or, if
available, reset to the manufacturer specific default values
<AcTtype>
integer
N/A
type of access technology.
Values:
0
:
Access technology is not using eDRX. This parameter value is only
used in the unsolicited result code, it cannot be used in the set
command.
2
:
GSM (A/Gb mode)
4
:
E-UTRAN (CAT M1 mode)
5
:
E-UTRAN (NB1 mode)
<Req_eDRX>
string
-
half a byte in a 4-bit format. The eDRX value refers to bit 4
to 1 of octet 3 of the Extended DRX parameters
information element (see subclause 10.5.5.32 of 3GPP TS
24.008). For the coding and the value range, see
Extended DRX parameters information element in 3GPP
TS 24.008, Table 10.5.5.32/3GPP TS 24.008. Default
value is "0000".
Additional info:

Telit Wireless Solutions ML865G1 Specifications

General

Brand	Telit Wireless Solutions
Model	ML865G1
Category	Wireless modules
Language	English