ME310G1/ME910G1/ML865G1 AT Commands Reference Guide
80617ST10991A Rev.4 Page 347 of 545 2020-04-15
3.12.10. AT+CGEREP - Packet Domain Event Reporting
This command enables or disables the presentation of unsolicited result codes.
AT+CGEREP=[<mode>[,<bfr>]]
Set command enables/disables sending of unsolicited result codes in case of certain events
occurring in the module or in the network. The URC formats and related events are shown in the
Additional info sections.
Parameters:
controls the processing of URCs specified with
this command.
buffer unsolicited result codes in the TA. If TA result code buffer is full, the
oldest one can be discarded. No codes are forwarded to the TE.
discard unsolicited result codes when TA-TE link is reserved (e.g. in on-line
data mode); otherwise forward them directly to the TE.
buffer unsolicited result codes in the TA when TA-TE link is reserved (e.g.
in on-line data mode) and flush them to the TE when TA-TE link becomes
available; otherwise forward them directly to the TE.
controls the effect on buffered codes when
<mode> 1 or 2 is entered.
TA buffer of unsolicited result codes defined within this command is cleared
when <mode> 1 or 2 is entered.
TA buffer of unsolicited result codes defined within this command is flushed
to the TE when <mode> 1 or 2 is entered (OK response shall be given
before flushing the codes)
Packet Data Protocol type, which specifies the type of packet data
protocol
identifies the terminal in the address space applicable to the PDP
AT+CGEREP?
Read command returns the current <mode> and <bfr> settings, in the format: