Telit Wireless Solutions ML865G1 At Commands Reference Guide

ME310G1/ME910G1/ML865G1 AT Commands Reference Guide
80617ST10991A Rev.4 Page 25 of 545 2020-04-15
3. AT COMMANDS REFERENCES
General Control and Config
3.1.1. Command Line Prefixes
3.1.1.1. AT - Starting a Command Line
AT is the prefix used to start a command line.
ITU-T Recommendation V.25 ter
3GPP TS 27.007
SIM Presence
Setting saved
Can be aborted
MAX timeout
SELINT
Not required
No
No
-
2
AT
The prefix AT is a two-character abbreviation ("ATtention"), always used to start a command line
to be sent from TE to TA, with the only exception of AT#/ prefix. As a command, it can be issued
just to test if the device is responding to AT commands.

Telit Wireless Solutions ML865G1 Specifications

General

Brand	Telit Wireless Solutions
Model	ML865G1
Category	Wireless modules
Language	English