Telit Wireless Solutions ML865G1 At Commands Reference Guide

ME310G1/ME910G1/ML865G1 AT Commands Reference Guide
80617ST10991A Rev.4 Page 66 of 545 2020-04-15
3.1.2.35. AT#PSMRI - Power Saving Mode Ring Indicator
The command enables or disables the Ring Indicator pin response to an URC message while modem is in
power saving mode.
SIM Presence
Setting saved
Can be aborted
MAX timeout
SELINT
Required
Common profile
No
-
2
AT#PSMRI=<n>
Set command enables/disables the Ring Indicator pin response to an URC message while modem
is in power saving mode. If enabled, a negative going pulse is generated, when URC message for
specific event is invoked. The duration of this pulse is determined by the value of <n>.
Parameter:
Name
Type
Default
Description
<n>
integer
0
disables, enables/sets duration of the generated pulse.
Values:
0
:
disables RI pin response for URC message
50÷1150
:
enables RI pin response for URC messages with a duration specified
in ms
When RING signal from incoming call/SMS/socket listen is enabled, the behavior for
#PSMRI will be ignored.
The behavior for #PSMRI is invoked only when modem is in sleep mode AT+CFUN=5.
AT#PSMRI?
Read command reports the duration in ms of the pulse generated, in the format:
#PSMRI: <n>
AT#PSMRI=?
Test command reports the supported range of values for parameter <n>
The value set by command is stored in the profile extended section and doesn't depend on the
specific AT instance used to enter the command.

Telit Wireless Solutions ML865G1 Specifications

General

Brand	Telit Wireless Solutions
Model	ML865G1
Category	Wireless modules
Language	English