Telit Wireless Solutions ML865G1 At Commands Reference Guide

ME310G1/ME910G1/ML865G1 AT Commands Reference Guide
80617ST10991A Rev.4 Page 527 of 545 2020-04-15
3.23.2. GNSS Receiver
3.23.2.1. AT$GPSP - GNSS Controller Power Management
This command powers on/off GNSS controller .
SIM Presence
Setting saved
Can be aborted
MAX timeout
SELINT
Not required
Other
No
-
2
AT$GPSP=<status>
The set command manages the power-up/power-down of the GNSS controller.
Parameter:
Name
Type
Default
Description
<status>
string
0
indicates the power status that has to be set.
Values:
0
:
GNSS controller is powered down
1
:
GNSS controller is powered up
Power up clears GPS memory and then starts the GPS receiver. GPS data cleaning is
performed on the base of the current value of the <reset_type> parameter (see $GPSR).
GPS operation mode is performed on the base of the current values of $GPSSLSR
configuration (see $GPSSLSR).
AT$GPSP?
The read command reports the current value of the <status> parameter, in the format:
$GPSP: <status>
AT$GPSP=?
The test command reports the supported values range for parameter <status>.
<status> value is stored through $GPSSAV command.
GNSS controller is powered down
AT$GPSP=0
OK

Telit Wireless Solutions ML865G1 Specifications

General

Brand	Telit Wireless Solutions
Model	ML865G1
Category	Wireless modules
Language	English