Telit Wireless Solutions ML865G1 At Commands Reference Guide

ME310G1/ME910G1/ML865G1 AT Commands Reference Guide
80617ST10991A Rev.4 Page 421 of 545 2020-04-15
3.14.2. AT#FTPAPPEXT - FTP Append Extended
The command sends data on a FTP data port while the module is in command mode.
SIM Presence
Setting saved
Can be aborted
MAX timeout
SELINT
Required
No
No
-
2
AT#FTPAPPEXT=<bytesToSend>[,<eof>]
Execution command sends data on a FTP data port while the module is in command mode.
FTP data port must be previously opened by #FTPPUT (or #FTPAPP) with <connMode>
parameter set to command mode connection.
After command line is terminated with <CR>, the module responds sending a four characters
sequence prompt, and waits for the specified number of bytes:
<CR><LF><greater_than><space> (IRA 13, 10, 62, 32)
When <bytesToSend> bytes have been sent, operation is automatically completed. If (all or part of
the) data are successfully sent, then the response is:
#FTPAPPEXT: <sentBytes>
OK
If data sending fails for some reason, an error code is reported.
Parameters:
Name
Type
Default
Description
<bytesToSend>
integer
N/A
number of bytes to be sent
Value:
1÷1500
:
number of bytes
<eof>
integer
0
data port closure
Values:
0
:
normal sending of data chunk
1
:
close data port after sending data chunk
Additional info:
Parameters:
Name
Type
Default
Description
<sentBytes>
integer
N/A
the number of sent bytes
Value:
1÷1500
:
number of bytes
<sentBytes> could be less than <bytesToSend>.

Telit Wireless Solutions ML865G1 Specifications

General

Brand	Telit Wireless Solutions
Model	ML865G1
Category	Wireless modules
Language	English