Telit Wireless Solutions ML865G1 At Commands Reference Guide

ME310G1/ME910G1/ML865G1 AT Commands Reference Guide
80617ST10991A Rev.4 Page 344 of 545 2020-04-15
3.12.8. AT+CGPIAF - Printing IP Address Format
This command selects the printout format of the IPv6 address.
3GPP TS 27.007
SIM Presence
Setting saved
Can be aborted
MAX timeout
SELINT
Not required
No
No
-
2
AT+CGPIAF=[<IPv6_AddressFormat>[,<IPv6_SubnetNotation>[,<IPv6_LeadingZeros>
[,<Pv6_CompressZeros>]]]]
Parameters:
Name
Type
Default
Description
<IPv6_AddressFormat>
integer
0
selects the IPv6 address format. Relevant for
all AT command parameters that can hold an
IPv6 address.
Values:
0
:
use IPv4-like dot-notation. IP addresses, and subnetwork
mask if applicable, are dot-separated.
1
:
use IPv6-like colon-notation. IP address, and subnetwork
mask if applicable and when given explicitly, are separated
by a space.
<IPv6_SubnetNotation>
integer
0
selects the subnet-notation for remote address
and subnet mask. Setting does not apply if IPv6
address format <IPv6_AddressFormat>=0.
Values:
0
:
both IP address, and subnet mask are started explicitly,
separated by a space.
1
:
the printout format is applying /(forward slash) subnet-
prefix Classless Inter-Domain Routing (CIDR) notation.
<IPv6_LeadingZeros>
integer
0
selects whether leading zeros are omitted or
not. Setting does not apply if IPv6 address
format <IPv6_AddressFormat>=0.
Values:
0
:
leading zeros are omitted.
1
:
leading zeros are included.
<Pv6_CompressZeros>
integer
0
selects whether 1-n instances of 16-bit- zero
values are replaced by only "::". This applies
only once. Setting does not apply if IPv6
address format <IPv6_AddressFormat>=0.
Values:
0
:
no zero compression.
1
:
use zero compression.

Telit Wireless Solutions ML865G1 Specifications

General

Brand	Telit Wireless Solutions
Model	ML865G1
Category	Wireless modules
Language	English