Telit Wireless Solutions ML865G1 At Commands Reference Guide

ME310G1/ME910G1/ML865G1 AT Commands Reference Guide
80617ST10991A Rev.4 Page 167 of 545 2020-04-15
3.2.33. AT#MONI - Cell Monitor
This command is both a set and an execution command.
SIM Presence
Setting saved
Can be aborted
MAX timeout
SELINT
Required
No
No
-
2
AT#MONI[=[<number>]]
Set command sets one cell out of seven, in a neighbor list of the serving cell including it, from which
extract GSM/LTE related information.
After entering the set command, enter the execution command AT#MONI<CR> to get the
GSM/LTE related information for the selected cell and dedicated channel (if exists) in the format
shown, for each network, in the Additional info section.
Parameter:
Name
Type
Default
Description
<number>
integer
-
the parameter meaning depends on the network, see
Additional info section.
Additional info:
GSM network
Name
Type
Default
Description
<number>
integer
0
GSM network
Values:
0÷6
:
it is the ordinal number of the cell, in the neighbor list of the
serving cell.
7
:
it is a special request to obtain GSM-related information from
the whole set of seven cells in the neighbor list of the serving
cell
LTE network
Name
Type
Default
Description
<number>
integer
0
LTE network
Values:
0
:
it is the serving cell
1
:
it is the intra-frequency cells
2
:
it is the inter-frequency cells
3
:
it is the W-CDMA neighbor cells, the report message is empty.
4
:
it is the GSM neighbor cells
5,6
:
it is not available

Telit Wireless Solutions ML865G1 Specifications

General

Brand	Telit Wireless Solutions
Model	ML865G1
Category	Wireless modules
Language	English