Telit Wireless Solutions ML865G1 At Commands Reference Guide

ME310G1/ME910G1/ML865G1 AT Commands Reference Guide
80617ST10991A Rev.4 Page 315 of 545 2020-04-15
3.9.2. AT#ENHRST - Periodic Reset
Enable or Disable the one shot or periodic unit reset
SIM Presence
Setting saved
Can be aborted
MAX timeout
SELINT
Not required
Auto
No
-
2
AT#ENHRST=<mode>,<delay>
Set commands enables/disables the unit reset after the specified <delay> in minutes
Parameters:
Name
Type
Default
Description
<mode>
integer
0
Enable\Disable mode
Values:
0
:
disables the unit reset
1
:
enables the unit reset only one time (one shot reset)
2
:
enables periodically unit reset
<delay>
integer
-
time interval in minutes after that the unit reboots
The settings are saved automatically in NVM only if old or new <mode> value is 2, i.e.
unit set in periodic reset mode. Therefore, any change from 0 to 1 or conversely is not
stored in NVM.
The command AT#ENHRST=1,0 causes the immediate module reboot. If it follows an AT
command that stores some parameters in NVM, it is strongly recommended to insert a
delay of at least 5 sec before issuing it, to permit the complete NVM storing process.
AT#ENHRST?
Read command reports the current parameter settings in the following format:
#EHNRST: <mode>[,<delay>,<remainingTime>]
Additional info:
Read command parameter for <mode> =1 or 2.
Name
Type
Default
Description
<remainingTime>
integer
-
time in minutes remaining before next reset
AT#ENHRST=?
Test command reports supported range of values for parameters <mode> and <delay>.

Telit Wireless Solutions ML865G1 Specifications

General

Brand	Telit Wireless Solutions
Model	ML865G1
Category	Wireless modules
Language	English