Telit Wireless Solutions ML865G1 At Commands Reference Guide

ME310G1/ME910G1/ML865G1 AT Commands Reference Guide
80617ST10991A Rev.4 Page 440 of 545 2020-04-15
3.14.18. AT#FTPCFG - FTP Configuration
This command sets the time-out used when opening either the FTP control channel or the FTP traffic channel.
SIM Presence
Setting saved
Can be aborted
MAX timeout
SELINT
Required
No
No
-
2
AT#FTPCFG=<tout>,<IPPignoring>[,<FTPSEn>[,<FTPext>]]
Parameters:
Name
Type
Default
Description
<tout>
integer
100
time out in 100 milliseconds units
Value:
100÷5000
:
hundreds of ms
<IPPignoring>
integer
N/A
enable or disable IP private ignoring
Values:
0
:
No IP Private ignoring. During a FTP passive mode connection client
uses the IP address received from server, even if it is a private IPV4
address.
1
:
IP Private ignoring enabled. During a FTP passive mode connection
if the server sends a private IPV4 address the client doesn’t consider
this and connects with server using the IP address used in
#FTPOPEN.
<FTPSEn>
integer
0
disable FTPS security
Values:
0
:
disable FTPS security: all FTP commands will perform plain FTP
connections.
1
:
enable FTPS security
<FTPext>
integer
1
PORT/PASV and EPRT/EPSV commands.
Option added to pass-through firewall that is
unaware of the extended FTP commands for
#FTPPUT, #FTPLIST, #FTPAPP, #FTPGET.
Values:
0
:
always use EPRT and EPSV commands
1
:
if both module and server ipv4 use PORT and PASV commands
If parameter <tout> is omitted the behavior of set command is the same as read
command.
AT#FTPCFG?
Read command reports the currently selected parameters in the format:

Telit Wireless Solutions ML865G1 Specifications

General

Brand	Telit Wireless Solutions
Model	ML865G1
Category	Wireless modules
Language	English