Telit Wireless Solutions ML865G1 At Commands Reference Guide

ME310G1/ME910G1/ML865G1 AT Commands Reference Guide
80617ST10991A Rev.4 Page 535 of 545 2020-04-15
Mobile Broadband
3.24.1. Ethernet Control Mode (ECM)
3.24.1.1. AT#ECM - Ethernet Control Model Setup
This command sets up an Ethernet Control Model (ECM) session.
SIM Presence
Setting saved
Can be aborted
MAX timeout
SELINT
Not required
Auto
No
-
2
AT#ECM=<Cid>,<Did>
Parameters:
Name
Type
Default
Description
<Cid>
integer
-
context id that will be used by ECM. Refer to test command to
know the supported range of values.
<Did>
integer
-
device id, currently limited to 0 (only one device)
To enable the ECM session configuration the module must be rebooted.
To activate an ECM session a compatible USB configuration has to be set; for details
refer to the description of #USBCFG.
AT#ECM?
Read command returns the session state in the following format:
# ECM: <Did>,<State>
OK
Additional info:
Here are the parameters meaning returned by the read command and not described in the
previous sections.
Name
Type
Default
Description
<State>
integer
0
ECM session status.
Values:
0
:
disabled
1
:
enabled
AT#ECM=?
Test command returns the range of supported values for all the parameters.

Telit Wireless Solutions ML865G1 Specifications

General

Brand	Telit Wireless Solutions
Model	ML865G1
Category	Wireless modules
Language	English