Telit Wireless Solutions ML865G1 At Commands Reference Guide

ME310G1/ME910G1/ML865G1 AT Commands Reference Guide
80617ST10991A Rev.4 Page 117 of 545 2020-04-15
3.2.4. AT+COPS - Operator Selection
The command selects a network operator and registers the module.
3GPP TS 27.007
SIM Presence
Setting saved
Can be aborted
MAX timeout
SELINT
Required
Auto
No
-
2
AT+COPS=[<mode>[,<format>[,<oper>[,<act>]]]]
The set command attempts to select a network operator and registers the module on the just
chosen operator; the selection can be automatic or manual.
Parameters:
Name
Type
Default
Description
<mode>
integer
0
defines the operator selection: automatic or manual.
Values:
0
:
automatic selection, the parameter <oper> is ignored
1
:
manual selection, the parameter <oper> must be present
2
:
deregister from network. The module is unregistered until a +COPS with
<mode>=0, 1 or 4 is issued
3
:
set only <format> parameter, the parameter <oper> is ignored
4
:
manual/automatic, <oper> parameter must be present. If manual selection
fails, the module will tray automatic mode (<mode>=0)
<format>
integer
0
specifies the operator name format, see <oper>
parameter
Values:
0
:
alphanumeric long form (max length 16 digits)
1
:
alphanumeric short form
2
:
numeric 5 or 6 digits [country code (3) + network code (2 or 3)]
<oper>
mixed
-
network operator in format defined by <format>
parameter
<act>
integer
N/A
selects access technology.
Values:
0
:
GSM
8
:
CAT M1
9
:
NB IoT
<mode> parameter setting is stored in NVM and available at next reboot. <mode>=3 is
not saved.
If <mode>=1 or 4, the selected network is stored in NVM too and is available at next
reboot (this will happen also after inserting another SIM).

Telit Wireless Solutions ML865G1 Specifications

General

Brand	Telit Wireless Solutions
Model	ML865G1
Category	Wireless modules
Language	English