ME310G1/ME910G1/ML865G1 AT Commands Reference Guide
80617ST10991A Rev.4 Page 228 of 545 2020-04-15
DTR signal is ignored, hence the indication is sent even if the DTE is inactive (DTR signal
is Low). In this case the unsolicited result code may be lost so if MODULE remains active
while DTE is not, at DTE startup is suggested to check whether new messages have
reached the device meanwhile with command AT+CMGL=0 that lists the new messages
received.
AT+CNMI?
Read command returns the current parameter settings for +CNMI command in the form:
+CNMI: <mode>,<mt>,<bm>,<ds>,<bfr>
AT+CNMI=?
Test command reports the supported range of values for the +CNMI command parameters
AT+CMGF=1
OK
AT+CNMI=1,2,0,1,0
OK
Received message from network
+CMT: "+821020955219",,"07/07/26,20:09:07+36"
TEST MESSAGE
To Next Page
Loading...
Need help?
General
