Telit Wireless Solutions ML865G1 At Commands Reference Guide

ME310G1/ME910G1/ML865G1 AT Commands Reference Guide
80617ST10991A Rev.4 Page 246 of 545 2020-04-15
Name
Type
Description
<index>
integer
message location index in the memory <memw> (see +CPMS). If
message storing fails for some reason, an error code is reported.
The DCD signal shall be in ON state while <data> is entered. The echoing of <data> is
controlled by echo command E.
In PDU mode, not only SUBMIT messages can be stored in SIM, but also DELIVER
and STATUS REPORT messages (3GPP TS 23.040 SMS-STATUS-REPORT
messages). SUBMIT messages can only be stored with status 2 or 3; DELIVER and
STATUS REPORT messages can only be stored with status 0 or 1.
Care must be taken to ensure that during the command execution, which may take
several seconds, no other SIM interacting commands are issued.
It is possible to save a concatenation of at most 10 SMs; the maximum number of chars
depends on <dcs>:
• 2448 chars
• 2144 chars if 8-bit is used
• 1072 chars if UCS2 is used
In text mode, not only SUBMIT messages can be stored in SIM, but also DELIVER
messages.
The type of saved message depends upon the current <fo> parameter (see +CSMP).
For a DELIVER message, current <vp> parameter (see +CSMP) is used to set the
message Service Centre Time Stamp <scts>, so it must be an absolute time string,
e.g. "09/01/12,11:15:00+04".
SUBMIT messages can only be stored with status "STO UNSENT" or "STO SENT";
DELIVER messages can only be stored with status "REC UNREAD" or "REC READ".
If message writing fails for some reason, then an error code is reported.
AT+CMGW=?
Test command returns the OK result code.
To avoid malfunctions it is suggested to wait for the +CMGW: <index> or +CMS ERROR:
<err> response before issuing further commands.

Telit Wireless Solutions ML865G1 Specifications

General

Brand	Telit Wireless Solutions
Model	ML865G1
Category	Wireless modules
Language	English