Telit Wireless Solutions ML865G1 At Commands Reference Guide

ME310G1/ME910G1/ML865G1 AT Commands Reference Guide
80617ST10991A Rev.4 Page 283 of 545 2020-04-15
If the DST information isn't sent by the network, then the <datetime> parameter will have
the format "yy/MM/dd,hh:mm:ss±zz".
Date and time information can be sent by the network after GSM registration or after PS
attach.
AT#NITZ?
Read command reports whether
• automatic date/time updating
• Full Network Name applying
• #NITZ URC (as well as its format)
are currently enabled or not in the format:
#NITZ: <val>,<mode>
AT#NITZ=?
Test command returns supported values of parameters <val> and <mode>.
The command parameters are stored in two different profiles:
• <val> must be valid for all AT instances, so its value is entered in Common profile
(extended section).
• <mode> must be valid only for the AT instance where it has been set, so its value is
entered in Specific profile (extended section).
Use the #W[<n>] command to store the updated profiles in NVM.

Telit Wireless Solutions ML865G1 Specifications

General

Brand	Telit Wireless Solutions
Model	ML865G1
Category	Wireless modules
Language	English