ME310G1/ME910G1/ML865G1 AT Commands Reference Guide
80617ST10991A Rev.4 Page 351 of 545 2020-04-15
not registered, terminal is not currently searching a
new operator to register to
not registered, but terminal is currently searching a
new operator to register to
the parameter reports:
• Local Area Code when <AcT>=0
• Tracking Area Code when <AcT>=8 or 9
cell ID in hexadecimal format
access technology of the registered network.
Values:
routing area code (one byte) in hexadecimal format
one byte in an 8 bit format. Indicates the Active Time value
(T3324) allocated to the UE. The Active Time value is coded
as one byte (octet 3) of the GPRS Timer 2 information
element coded as bit format (e.g. "00100100" equals 4
minutes). For the coding and the value range, see the GPRS
Timer 2 IE in 3GPP TS 24.008.
one byte in an 8 bit format. Indicates the extended periodic
RAU value (T3312) allocated to the UE. The extended
periodic RAU value s coded as one byte (octet 3) of the
GPRS Timer 3 information element coded as bit format (e.g.
"01000111" equals 70 hours). For the coding and the value
range, see the GPRS Timer 3 IE in 3GPP TS 24.008.
one byte in an 8 bit format. Indicates the GPRS READY
timer value (T3314) allocated to the UE. The GPRS READY
timer value is coded as one byte (octet 2) of the GPRS Timer
information element coded as bit format (e.g. "01000011"
equals 3 decihours or 18 minutes). For the coding and the
value range, see the GPRS Timer IE in 3GPP TS 24.008.
<lac>
, <ci>
, <AcT>
, and <rac>
network information is reported by URC only if <mode>=2 or 4, and the module is registered on some network cell.
AT+CGREG?
Read command returns the current value of <mode>, the registration status <stat>, and the
network information (<lac>, <ci>, <AcT>, and <rac> ) according to the used <mode> parameter
value.
+CGREG: <mode>,<stat>[,<lac>,<ci>[,<AcT>,<rac>]]
To Next Page
Loading...
Need help?
General
