Telit Wireless Solutions ML865G1 At Commands Reference Guide

ME310G1/ME910G1/ML865G1 AT Commands Reference Guide
80617ST10991A Rev.4 Page 467 of 545 2020-04-15
Additional info:
<connMode>=0: online mode connection
If <connMode> is set to online mode connection and the command is successful, the
module enters into online data mode and returns the intermediate result code CONNECT.
After the CONNECT, you can suspend the direct interface to the socket connection (the
socket stays open) using the escape sequence (+++): the module moves back to
command mode and returns the final result code OK after the suspension.
After such a suspension, it is possible to resume it by using the #SSLO command with the
corresponding <connId>.
<connMode>=1: command mode connection
If <connMode> is set to command mode connection and the command is successful,
the socket is opened, the module remains in command mode and returns result code OK.
If secure socket is not enabled using #SSLEN only test requests can be made.
If timeout is not set for SSL connection the default timeout value, set by #SSLCFG, is
used.
In online mode the socket is closed after an inactivity period (configurable with #SSLCFG,
with a default value of 90 seconds), and the NO CARRIER message is printed.
In online mode data are transmitted as soon as the data packet size is reached or as after
a transmission timeout. Both these parameters are configurable by using #SSLCFG.
Before opening a SSL connection, the PDP context must have been activated by
#SGACT=x,1
Before opening a SSL connection, make sure to have stored the needed secure data (CA
certificate), using #SSLSECDATA, for the security level set through AT#SSLSECCFG.
The PDP context definition that will be used, is set by AT#SSLCFG command
AT#SSLD=?
Test command returns the range of supported values for all the parameters:
#SSLD: (1),(1-65535),,(0),(0,1),(1-5000)

Telit Wireless Solutions ML865G1 Specifications

General

Brand	Telit Wireless Solutions
Model	ML865G1
Category	Wireless modules
Language	English