FLIGHT PHASES
8 CRUISE
Lateral functions
Normal lateral mode is NAV providing lateral guidance to maintain
ACTIVE F-PLN track.
Lateral functions DIR TO, HOLD, OFFSET, are described in Part III:
Multiphase – Lateral functions.
Vertical functions
Vertical functions are accessed through
VERT REV on F-PLN page.
UTC CSTR [2R], SPD CSTR [3L], ALT
CSTR [3R] enable insertion of
Time/Speed/Altitude constraints at a
WPT in ACTIVE F-PLN.
STEP ALTS prompt [5R] may be used if
a level change is expected at a specific
WPT of the route.
ACCESS WIND DATA prompt [5L] may
be used to insert or update winds
manually or by Data Link (if available).
These functions are described in Part
III: Ch 4 – Vertical F-PLN
management.
FROM THV001 {}
UTC SPD/ALT
T-P 1100 / FL358
BRG357° 68
ADABI 1114 .79/ FL360
UN874 TRK016° 30
BOKNO 1118 " / "
UN874 27
DEVRO 1121 " / "
UN874 22NM
VANAD 1124 " / "
DEST UTC DIST EFOB
EGLL27R 1208 408 4.0
£$
VERT REV AT VANAD
EFOB=5.1 EXTRA=1.1
CLB SPD LIM UTC CSTR
250/FL100 [ ]
SPD CSTR ALT CSTR
[ ] [ ]
ACCESS
<WIND DATA STEP ALTS>
<RETURN
J43126AA 00
© THALES AVIONICS S.A.
AIRBUS A318/319/320/321
To Next Page
Loading...