MULTIPHASE
DATA LINK 39
WIND DATA UPLINK scratchpad messages
During WIND DATA UPLINK some scratchpad messages are displayed
or stacked to advise pilot of stages in the processing.
These messages are listed below and are fully described in
APPENDICES.
Normal messages
WIND DATA UPLINK
Advises pilot that valid uplinked wind data are available for review in
either flight plan.
Additional messages
CHECK DEST DATA
Displayed in CRZ phase when distance to destination is less than 180
NM and QNH, TEMP or WIND at destination displayed on the current
active APPR PERF page result from an AOC uplink.
Maybe displayed after the WIND DATA UPLINK message when a conflict
exists.
CHECK ALTN WIND
Displayed if the uplinked ALTN CRZ level differs from the FMS ALTN
CRZ level.
Note:
In there are several messages, the display order is: WIND DATA
UPLINK, CHECK DEST DATA, CHECK ALTN WIND.
Error messages
INVALID WIND UPLINK
Displayed if wind uplink message is rejected.
WIND UPLINK EXISTS
A flight plan modification (active or secondary) is attempted when
uplink winds are not yet inserted.
This message is automatically cleared when the wind uplink is inserted
or erased.
AIRBUS A318/319/320/321
© THALES AVIONICS S.A.
J43126AA 00
To Next Page
Loading...