MULTIPHASE
VERTICAL F-PLN management 23
4.2. WIND DATA
Access
WIND DATA for the ACTIVE F-PLN may be accessed from:
− DATA INDEX page 2/2 via ACTIVE F-PLN WINDS at [5L], or
− F-PLN page, via VERT REV page at a WPT and ACCESS WIND DATA
prompt at [5L].
This prompt is not available when a TMPY F-PLN exists and in
go-around procedure until go-araound is initiated.
WIND DATA for the SEC F-PLN may be accessed from :
− DATA INDEX page 2/2 via SEC F-PLN WINDS at [6L], or
− F-PLN page, via VERT REV page at a WPT and ACCESS WIND DATA
prompt at [5L] .
Access to WIND is also available from INIT page A (SEC INIT page A)
via WIND prompt at [5R].
This is a normal access to ACTIVE WIND DATA during the cockpit
preparation. See Part II: Ch 2.1 Preflight
Following pages show access:
− From DATA INDEX page 2/2 CLIMB WIND page is displayed first,
− From VERT REV pages, WIND page for the current phase is
displayed.
The WIND REQUEST prompt is displayed if AOC option is activated.
*
symbol adjacent to WIND REQUEST prompt is not displayed when a
request is sent or when data link is not available.
See Part III: Ch 9 Data Link
When accessed via VERT REV pages at a WPT, the display is CLIMB /
CRUISE / DESCENT WIND page according to the phase at which the
WPT is belonging.
AIRBUS A318/319/320/321
© THALES AVIONICS S.A.
J43126AA 00
To Next Page
Loading...