Thales FMGS - Auto-Print

MULTI PHASE
6 PRINT FUNCTION
 Auto-print
Auto print status is displayed in fields
[1L] to [3L] of PRINT FUNCTION pages.
Indications may be:
PRINT FUNCTION 1/2 {}
AUTO MANUAL
*YES F-PLN INIT PRINT*
TO DATA PRINT*
*NO WIND DATA PRINT*
AOC
<RETURN FUNCTION>
− *NO,
− NO,
− *YES, or
− Blank.
These indications are set according
operator's selection in AMI file:
PRINT FUNCTION 2/2 {}
AUTO MANUAL
*YES PREFLIGHT PRINT*
*YES INFLIGHT PRINT
*YES POSTFLIGHT PRINT
SEC F-PLN PRINT*
AOC
<RETURN FUNCTION>
− (*) prompt means that pilot may select
the opposite status,
− If (*) is not displayed the status is not
modifiable,
− Blank field means the function is not
activated.
During an auto-print, (*) of the
corresponding manual print disappears
and re-appears when print is completed.
Modification of auto-print status:
For example:
[1L].............................. PRESS
Auto-print status of F-PLN INIT
changes from YES to NO.
Auto-print of this report is no longer
available.
Print is aborted if
* YES is pressed
while a print is in process.
Auto-print reports occur:
PRINT FUNCTION 1/2 {}
AUTO MANUAL
*YES F-PLN INIT PRINT*
TO DATA PRINT*
*NO WIND DATA PRINT*
AOC
<RETURN FUNCTION>
PRINT FUNCTION 1/2 {}
AUTO MANUAL
*NO F-PLN INIT PRINT*
TO DATA PRINT*
*NO WIND DATA PRINT*
AOC
<RETURN FUNCTION>
− At engine Start for Preflight report,
− When switching to Take Off phase
for In-flight report,
− At engine Shutdown for the Post-
flight report.
J43126AA 00
© THALES AVIONICS S.A.
AIRBUS A318/319/320/321