Thales FMGS - To Delete CLB or des SPD LIM

MULTIPHASE
VERTICAL F-PLN management 5
AIRBUS A318/319/320/321
© THALES AVIONICS S.A.
J43126AA 00
FROM TMPY THV001 {}
UTC SPD/ALT
D144H} 0300 / 3810
C356° BRG325° 8
TOU 1138 305/ FL123
TRK357° 37
(T/C) 1144 .79/ FL360
FIST5A 10
FISTO 1145 " / "
UN874 84M
FOUCO 1157 " / "
TMPY TMPY
{ERASE INSERT*
$£
 To delete CLB or DES SPD LIM
From F-PLN page, access VERT
REV page by right LSK, at any
WPT before T/D for CLB, or after
T/D for DES.
VERT REV at WPT .......... Press
Ex: TOU
VERT REV page is displayed.
CLR key ........................ Press
[2L] .............................. Press
TMPY F-PLN page is displayed;
SPD LIM pseudo waypoint is
deleted.
If VERT REV again selected from
TMPY F-PLN, SPD LIM field shows
brackets.
There is no reversion to
default values.
TMPY INSERT [6R] ........ Press
SPD LIM is deleted from ACTIVE
F-PLN.
If a go-around is initiated, SPD
LIM values remain unchanged, at
values of previous DES SPD LIM.
See also Part II: CLIMB and
DESCENT phases.
Note
Vertical constraints may be modified or cleared directly on F-PLN pages
via right LSKs.
This method is not recommended, since a possible simultaneous leg-
switching could cause inadvertent revision of the adjacent WPT.
FROM THV001 {}
UTC SPD/ALT
D144H} 0300 / 3810
C356° BRG339° 10
TOU 1137 280/ FL123
(SPD) TRK357° 4
(LIM) 1138 *280/ FL150
33
(T/C) 1143 .79/ FL360
FIST5A 10NM
FISTO 1144 " / "
DEST UTC DIST EFOB
EGLL27R 1256 529 4.3
£$
VERT REV AT TOU
EFOB=7.1 EXTRA=1.3
CLB SPD LIM UTC CSTR
280/FL150 [ ]
SPD CSTR ALT CSTR
[ ] [ ]
ACCESS
<WIND DATA STEP ALTS>
<RETURN
CLR
VERT REV AT TOU
EFOB=7.1 EXTRA=1.4
CLB SPD LIM UTC CSTR
*[]/[ ] [ ]
SPD CSTR ALT CSTR
[ ] [ ]
STEP ALTS>
TMPY
{F-PLN
FROM THV001 {}
UTC SPD/ALT
D144H} 0300 / 3810
C356° BRG339° 10
TOU 1138 305/ FL123
TRK357° 37
(T/C) 1144 .79/ FL360
FIST5A 10
FISTO 1145 " / "
UN874 84NM
FOUCO 1157 " / "
DEST UTC DIST EFOB
EGLL27R 1257 529 4.3
£$