EasyManua.ls Logo

Thales FMGS - Use of PROG CRUISE Page

Thales FMGS
703 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
FLIGHT PHASES
CRUISE 15
5.5. Use of PROG CRUISE page
CRZ OPT RECMAX (Line 1)
CRZ [1L]
This field is updated when a new altitude
is selected on the FCU.
It cannot be cleared, but may be
modified by a new entry.
Entering a higher ALT switches FMGS to
CLIMB phase.
To enter a lower ALT distance to DEST
must be less than 200 NM; in this case
FMGS phase switches to DESCENT
phase.
OPT [center]
Shows optimum flight level, based on the actual gross weight, cost
index, temperature and winds.
Is displayed if a minimum of 15 minutes cruise-time exists.
REC MAX [1R]
As for CLIMB page.
<REPORT prompt [2L]
This function may be used for position message to ATC or Data Link (if
available).
Refer to Part III: PROG page & Data Link
UPDATE AT [3L]
Enables FMGC update position at a navaid.
See Part III: Ch 7.3 – Position Monitoring.
CRUISE THV001
CRZ OPT REC MAX
FL360 FL360 FL388
<REPORT
UPDATE AT
*[ ]
BRG /DIST
355° /366.5 TO EGLL27R
PREDICTIVE
<GPS GPS PRIMARY
REQUIRED ACCUR ESTIMATED
2.0NM HIGH 0.08NM
AIRBUS A318/319/320/321
© THALES AVIONICS S.A.
J43126AA 00

Table of Contents