Thales FMGS - Page 290

6
FLIGHT PHASES
DONE
J43126AA 00
© THALES AVIONICS S.A.
AIRBUS A318/319/320/321
 Full-stop landing
The FMS phase will switch to DONE 30 sec after touch-down, and the
entire ACTIVE F-PLN and PERF data are deleted.
It is therefore recommended to prepare the SEC F-PLN as follows.
SEC F-PLN key................Press
 If a SEC F-PLN exists,
DELETE SEC [3L] .......Press
Then,
INIT [1R].......................Press
SEC INIT A page is displayed.
If NAV data base contains an
appropriate training circuit pattern
stored as a CO RTE, insert code on SEC
INIT page. This pattern is then entered
in SEC F-PLN and shown on ND.
Otherwise on SEC F-PLN page enter
take-off RWY and approach procedure,
and define circuit pattern if desired.
Complete SEC INIT B page.
Then, return to SEC INDEX page, PERF
prompt is now shown,
PERF [2R] ......................Press
Complete SEC PERF pages as required.
If SEC INIT B page and SEC PERF pages are not completed, managed
modes are not available.
SEC INDEX
{COPY ACTIVE INIT>
<SEC F-PLN
SEC F-PLN
PRINT*
SEC INDEX
{COPY ACTIVE
<SEC F-PLN
{DELETE SEC
*ACTIVATE SEC
SEC F-PLN
PRINT*
SEC INIT {}
CO RTE FROM/TO
[ ] [ ]/[ ]
ALTN/CO RTE INIT
----/---------- REQUEST
FLT NBR
[ ]
LAT LONG
----.-- -----.--
COST INDEX
--- WIND>
CRZ FL/TEMP TROPO
----- /---° 36090
SEC INIT {}
CO RTE FROM/TO
BLUE LFBO/LFBO
ALTN/CO RTE INIT
NONE REQUEST
FLT NBR
[ ]
LAT LONG
4338.1N 00122.1E
COST INDEX
68 WIND>
CRZ FL/TEMP TROPO
FL020 / 11° 36090
SEC INDEX
{COPY ACTIVE INIT>
<SEC F-PLN PERF>
{DELETE SEC
*ACTIVATE SEC
SEC F-PLN
PRINT*