TP-Link T2500G-10TS - Ip Dhcp Snooping Information Circuit-ID

Example
Enable and configure the customized sub-option Remote ID for the Option 82
as tplink on port 1/0/1:
T2500G-10TS(config)# interface gigabitEthernet 1/0/1
T2500G-10TS(config)# ip dhcp snooping information remote-id tplink
13.9 ip dhcp snooping information circuit-id
Description
The ip dhcp snooping information circuit-id command is used to enable and
configure the customized sub-option Circuit ID for the Option 82. To return to
the default Circuit ID for the Option 82, please use no ip dhcp snooping
information circuit-id command.
Syntax
ip dhcp snooping information circuit-id string
no ip dhcp snooping information circuit-id
Parameter
string ——Enter the sub-option Circuit ID, which contains 32 characters at
most.
Command Mode
Interface Configuration Mode (interface gigabitEthernet / interface range
gigabitEthernet)
Privilege Requirement
Only Admin, Operator and Power User level users have access to these
commands.
Example
Enable and configure the customized sub-option Circuit ID for the Option 82
as tplink on port 1/0/1:
T2500G-10TS(config)# interface gigabitEthernet 1/0/1
T2500G-10TS(config)#ip dhcp snooping information circuit-id tplink
99