TP-Link T2500G-10TS - Switchport General Allowed Vlan

Example
Configure the link type of port 2 as trunk and add it to all the VLANs:
T2500G-10TS(config)#interface gigabitEthernet 1/0/2
T2500G-10TS(config-if)#switchport mode trunk
T2500G-10TS(config-if)# switchport trunk allowed vlan all
3.8 switchport general allowed vlan
Description
The switchport general allowed vlan command is used to add the desired
General port to IEEE 802.1Q VLAN, or to remove a port from the
corresponding VLAN.
Syntax
switchport general allowed vlan vlan-list { tagged | untagged }
no switchport general allowed vlan
vlan-list
Parameter
vlan-list —— VLAN ID list, ranging from 2 to 4094, in the format of 2-3, 5. It is
multi-optional.
tagged | untagged —— egress-rule.
Command Mode
Interface Configuration Mode (interface gigabitEthernet / interface range
gigabitEthernet)
Privilege Requirement
Only Admin, Operator and Power User level users have access to these
commands.
Example
Configure Gigabit Ethernet port 1/0/4 whose link type is “general” to VLAN 2
and its egress-rule as “tagged”:
T2500G-10TS(config)#interface gigabitEthernet 1/0/4
T2500G-10TS(config-if)#switchport mode general
T2500G-10TS(config-if)#switchport general allowed vlan 2 tagged
33