TP-Link T2500G-10TS - Qos-Remark

Example
Edit the actions for policy1. Specify the mirror port as Gigabit Ethernet port
1/0/2 for the data packets matching ACL 120:
T2500G-10TS(config)#access-list policy action policy1 120
T2500G-10TS(config-action)#s-mirror interface gigabitEthernet 1/0/2
28.16 qos-remark
Description
The qos-remark command is used to configure QoS Remark function of
policy action.
Syntax
qos-remark [ dscp dscp ] [ priority pri ]
no qos-remark
Parameter
dscp —— DSCP of QoS Remark. Specify the DSCP region for the data
packets matching the corresponding ACL. DSCP ranges from 0 to 63. By
default, it is not limited.
pri —— Local Priority of QoS Remark. Specify the local priority for the data
packets matching the corresponding ACL. Local Priority ranges from 0 to 7.
Command Mode
Action Configuration Mode
Privilege Requirement
Only Admin, Operator and Power User level users have access to these
commands.
Example
Edit the actions for policy1. For the data packets matching ACL 120, specify
the DSCP region as 30 and local priority 2:
T2500G-10TS(config)#access-list policy action policy1 120
T2500G-10TS(config-action)# qos-remark dscp 30 priority 2
220