TP-Link T2500G-10TS - Show Spanning-Tree Mst

Parameter
port —— The Ethernet port number.
Command Mode
Privileged EXEC Mode and Any Configuration Mode
Privilege Requirement
None.
Example
Display the protect information of all ports:
T2500G-10TS(config)# show spanning-tree interface-security
Display the protect information of port 1:
T2500G-10TS(config)# show spanning-tree interface-security
gigabitEthernet 1/0/1
Display the interface security bpdufilter information:
T2500G-10TS(config)# show spanning-tree interface-security bpdufilter
29.26 show spanning-tree mst
Description
The show spanning-tree mst command is used to display the related
information of MST Instance.
Syntax
show spanning-tree mst { configuration [ digest ] | instance instance-id
[ interface [ gigabitEthernet port ] }
Parameter
instance-id —— Instance ID desired to show, ranging from 1 to 8.
port —— The Ethernet port number.
Command Mode
Privileged EXEC Mode and Any Configuration Mode
Privilege Requirement
None.
Example
Display the region information and mapping information of VLAN and MST
Instance:
242