TP-Link T2500G-10TS - Show Interface Switchport

Privilege Requirement
None.
Example
Display the information of vlan 5:
T2500G-10TS(config)# show vlan id 5
3.13 show interface switchport
Description
The show interface switchport command is used to display the IEEE 802.1Q
VLAN configuration information of the specified port/port channel.
Syntax
show interface switchport [ gigabitEthernet port ]
Parameter
port —— The port number.
Command Mode
Privileged EXEC Mode and Any Configuration Mode
Privilege Requirement
None.
Example
Display the VLAN configuration information of all ports and port channels:
T2500G-10TS(config)# show interface switchport
36